Altronix eFlow104NA8V Access Power Controller w/ Power Supply/Charger, 8 Fused Relay Outputs, 24VDC @ 10A, Aux Output, FAI, 220VAC, BC400 Enclosure
Technical Specification
- Make: Altronix
- Model code: eFlow104NA8V
- Input Voltage: 220 V AC
- Output Voltage: 24 V DC
- No of Outputs: 8
Altronix eFlow104NA8V unit distribut and switch power to access control systems and accessories. It converts a 220VAC 50/60Hz input into eight (8) independently controlled 24VDC fuse protected outputs with a total of 10A continuous supply current. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. Unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.
Read moreMake | Altronix |
---|---|
Manufacturer | Altronix |
Category | CCTV>Power supplies & batteries |
Model code | eFlow104NA8V |
Input Voltage | 220 V AC |
Output Voltage | 24 V DC |
No of Outputs | 8 |
Power Supplies & Batteries | Yes |
Environmental Specifications |
Operating Temperature C: 0 ~ 49 C (32 ~ 120 F ) Operating Humidity %: 85 |
Physical Specifications |
Dimension mm: 311 x 394 x 114 Weight g: 4040 |
Additional info |
Altronix eFlow104NA8V unit distribut and switch power to access control systems and accessories. It converts a 220VAC 50/60Hz input into eight (8) independently controlled 24VDC fuse protected outputs with a total of 10A continuous supply current. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. Unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs. |
Download PDF version Download PDF version |
The 2024 state of physical access trend report
DownloadThe security challenges of data centers
DownloadSecurity practices for hotels
DownloadHow to solve the disparate systems challenge
DownloadFacial recognition
Download